| 泡罩包装机 操作方法 |
| 添加时间：2019/7/30 9:34:20 浏览次数： |
| 操作方法 Operating method ①备好药品、包材，更换批号字模板，安装好PVC及铝箔，检查冷却水，认真清洁设备； [1] (1) Prepare medicines and packaging materials, change batch number template, install PVC and aluminum foil, check cooling water and clean equipment carefully; [1] ②打开电源开关，接通压缩空气； (2) Turn on the power switch and turn on the compressed air; ③按下加热键，并分别将加热和热封温控表调至合适温度； (3) Press the heating key and adjust the heating and sealing temperature control tables to the appropriate temperature. ④将PVC硬片经过通道拉至冲切刀下，将铝箔拉至热封板下； (4) Pull the PVC hard sheet under the punching cutter through the passage, and pull the aluminum foil under the heat sealing plate. ⑤加热板和热封板升至合适温度时，将冷却温度表调至合适温度（一般应为30℃）； (5) When the heating plate and the heat sealing plate are raised to the appropriate temperature, the cooling temperature meter should be adjusted to the appropriate temperature (generally 30 C). ⑥待药品布满整个下料轨道时，按下电机绿色按钮，开空车运行，待吹泡、热封和冲切都达到要求后，按下药片斗振动按钮和行星布料开关； _When the medicine fills the whole discharging track, press the green button of the motor and run the empty car. When the blowing, heat sealing and punching meet the requirements, press the vibration button of the tablet bucket and the planetary discharging switch. ⑦调节下料时，使下料合乎要求，进行正常包装； _When adjusting the cutting material, make the cutting material meet the requirements and pack normally. ⑧包装结束后，按以下顺序关机：按下药片斗关机按钮——按下电机红色按钮——主机停——关闭总电源开关——关闭进气阀——关闭进水阀。然后是清理机器及现场，保养包装设备 After packaging, shut down the machine in the following order: press the shutdown button of the tablet bucket - press the red button of the motor - stop the main engine - close the main power switch - close the intake valve - close the intake valve. Then clean up the machine and the site, and maintain the packaging equipment. |
| 上一页 工作原理及工艺流程 |
| 下一页 铝塑泡罩包装成为固体药品包装的主流 |
Copyright © 技术支持：遨游网络